Figure 1. Air Discharge Louver and Condenser Guard

TM 9-4120-430-14

0021 00

Clean with warm soapy water or dry cleaning solvent (Item 16, WP 0069 00).

Figure 1. Air Discharge Louver and Condenser Guard

INSTALLATION

Condenser Air Discharge Louver

1. Place condenser air discharge louver (7) into housing while inserting the louver linkage over the pin of the actuator-

linear pivot arm (9). Install retainer push-on nut (8) over pin of pivot arm (9).

2. Install five recessed screws (5) and two snap fastener cap screws (6) on the right side of the louver and on the top

and bottom of the louver. The left side of the louver uses the same screws that secure the condenser guard.

Condenser Guard

1. Install condenser guard (1) using five flat washers (4), lockwashers (3) and screws (2).

2. Attach top cover. See WP 0018 00.

3. Attach canvas cover. See WP 0017 00.

END OF WORK PACKAGE

0021 00-2