Figure 1. J1 Connector

TM 9-4120-430-14

0029 00

Figure 1. J1 Connector

NOTE

Use Schematic Diagram, WP 0038 00 for the following instructions.

REMOVAL

1. Verify all wire labels to wire lists and schematics (WP 0038 00) or tag all wire leads prior to removal.

2. Refer to WP 0027 00 for J2 connector removal.

3. For J1 connector removal, remove one screw (1) and nut (2) that attaches eyelet of J1 cover wire (3). See figure 1.

4. Remove three screws (4) and nuts (5) to remove J1 connector (6) and cover (7).

TEST

1. Test for continuity on wiring.

2. Touch the test probes of a multimeter, set on low-resistance range, to ends of wire and/or corresponding pin of

connector.

3. If continuity is not indicated, repair or replace wire or damaged connector.

0029 00-2