TM 10-8145-222-23
0009
PRELIMINARY SERVICE OF EQUIPMENT
Initial Equipment Inspection
1. Inspect container frame, corner posts, and upper/lower fittings for damage. Do not use containers damaged in
those areas (TM 10-8145-222-10).
2. Inspect exterior wall panels of container for punctures, tears, cracks, and loose or missing fasteners (TM 10-
8145-222-10).
3. Inspect doors for loose, missing, or broken hardware (TM 10-8145-222-10).
4. Inspect container interior for tears, cracks to ceiling and wall panels, and any other damage (TM 10-8145-222-
10).
5. Inspect container stencils, markings, and information plates. All items should be legible (TM 10-8145-222-10).
6. Notify service maintenance to fill fuel tank to appropriate level (WP 0012, Fuel).
7. Check engine oil in accordance with PMCS procedures (TM 10-8145-222-10).
8. Load paper in temperature chart recorder (TM 10-8145-222-10, Change Chart Paper).
WARNING
Electrical voltage and current cannot be seen, and when contacted can result in
death, render you unconscious, or severely burn you. Use extreme care when
working around or with energized equipment. Electricity is unlike most other
dangerous things you can come in contact with because it gives no warning. To
ensure your safety and that of other maintenance personnel, do not make electrical
connections unless you are trained and qualified to do so.
9. If using an external electrical source, make sure that power cable assemblies have been connected by qualified
personnel.
CAUTION
Receiver and compressor discharge valves must be opened before operating RU.
Damage to compressor will result if RU is operated with valves closed.
10. Release refrigerant into system (WP 0014, Release Refrigerant).
11. Start unit to ensure proper operation (TM 10-8145-222-10, Operating Procedures).
12. Place MTRCS back into desired mode of operation (TM 10-8145-222-10, Operating Procedures).
END OF TASK
END OF WORK PACKAGE
0009-2
