TM 10-8145-222-23
0058
REPAIR CONTINUED
Replace Fuel Outlet Assembly
WARNING
The JP-8 and diesel fuels used with the MTRCS are combustible and highly
explosive. Do not smoke or use open flame when performing maintenance. Flames
and explosion can occur resulting in severe injury or death.
The JP-8 and diesel fuels used with the MTRCS are toxic. Always wear eye, face,
and hand protection when working with or around fuel. If fuel contact is made with
eyes, flush your eyes and seek immediate medical attention. If fuel contact is made
with skin or clothing, remove contaminated clothing immediately, clean your skin with
a mild soap or cleanser, and rinse with clean water.
CAUTION
Fuel lines will have some fuel in them that will drain out when disconnected. Use
cleaning rags to clean up any spills when performing the following tasks.
NOTE
If fuel contamination has occurred, or is suspected, always remove and replace the
fuel outlet assembly after cleaning and purging tank.
1. Disconnect battery if not already disconnected (WP 0053, Disconnect).
2. Loosen 3/8-inch fuel feed line (Figure 6, Item 3) fitting from elbow (Figure 6, Item 4).
3. Remove fuel line (Figure 6, Item 2) from elbow (Figure 6, Item 3).
4. Clean any fuel leakage from line with machinery wiping towels.
NOTE
When removing the elbow from the fuel tank, make note of the positioning of the
elbow so that replacement elbow can be installed in the same position.
5. Remove elbow (Figure 6, Item 3) from fuel outlet assembly (Figure 6, Item 6) by turning in counterclockwise
direction.
6. Unscrew fuel outlet assembly (Figure 6, Item 6) in a counterclockwise direction from fuel tank (Figure 6, Item 5).
NOTE
The fuel outlet assembly extends to the bottom of the fuel tank and has a fuel strainer
attached to the end of the extension. Use care when removing the fuel outlet
assembly from the fuel tank.
7. Carefully remove fuel outlet assembly (Figure 6, Item 6) from fuel tank (Figure 6, Item 5).
0058-17
