TM 10-8145-222-23
0058
REPAIR CONTINUED
10. Apply sealant to threads of elbow (Figure 6, Item 3).
11. Install elbow (Figure 6, Item 3) into fuel outlet assembly (Figure 6, Item 6) by turning in clockwise direction.
12. Tighten elbow (Figure 6, Item 3) so that it aligns with position removed from.
13. Install fuel line (Figure 6, Item 2) to elbow (Figure 6, Item 3).
14. Tighten fuel line (Figure 6, Item 2).
15. Connect battery (WP 0053, Reconnect).
16. Start refrigeration unit using diesel engine mode (TM 10-8415-222-10, Operating Procedures).
17. Check elbow (Figure 4, Item 3) for leakage and repair if necessary per this WP.
18. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
Replace Fuel Tank Drain Hoses
WARNING
The JP-8 and diesel fuels used with the MTRCS are combustible and highly
explosive. Do not smoke or use open flame when performing maintenance. Flames
and explosion can occur resulting in severe injury or death.
The JP-8 and diesel fuels used with the MTRCS are toxic. Always wear eye, face,
and hand protection when working with or around fuel. If fuel contact is made with
eyes, flush your eyes and seek immediate medical attention. If fuel contact is made
with skin or clothing, remove contaminated clothing immediately, clean your skin with
a mild soap or cleanser, and rinse with clean water.
CAUTION
Fuel lines may have some fuel in them that will drain out when disconnected. Use
cleaning rags to clean up any spills when performing the following tasks.
1. Disconnect battery if not already disconnected (WP 0053, Disconnect).
2. Remove five hose clamps (Figure 5, Item 1) securing drain hoses (Figure 5, Item 2 and Item 3) to tee (Figure 5,
Item 4) and two drain cocks (Figure 5, Item 5).
3. Remove drain hoses (Figure 5, Item 2 and Item 3) and tee (Figure 5, Item 4).
4. Install drain hoses (Figure 5, Item 2 and Item 3) to tee (Figure 5, Item 4) in three locations and secure using
three hose clamps (Figure 5, Item 1).
5. Install drain hoses (Figure 7, Item 2 and Item 3) and tee (Figure 7, Item 4) to two drain cocks (Figure 7, Item 5)
and secure using two hose clamps (Figure 7, Item 1).
6. Tighten all hose clamps (Figure 7, Item 1).
0058-19
