TM 10-8145-222-23
0058
REPAIR CONTINUED
WARNING
Wear eye protection and gloves. Sealant may cause eye and skin irritation, and may
irritate respiratory system upon frequent or prolonged use. Avoid contact with eyes
and skin, and prolonged exposure to fumes. If contact is made with eyes, flush eyes
immediately with water for 15 minutes and seek medical attention. If contact is made
with skin, wash affected area with soap and water. If skin irritation persists, seek
medical attention. If swallowed, rinse mouth. Do not induce vomiting. Keep individual
calm and seek immediate medical attention. Failure to comply with this warning may
cause serious personal injury or death.
NOTE
When removing the elbow from the fuel tank, make note of the positioning of the
elbow so that replacement elbow can be installed in the same position.
6. Apply sealant to threads of replacement elbow (Figure 5, Item 3 or Item 4).
7. Install applicable elbow (Figure 5, Item 3 or Item 4) into fuel tank (Figure 5, Item 5) by turning in clockwise
direction.
8. Tighten elbow (Figure 5, Item 3 or Item 4) so that it aligns with position removed from.
9. Install applicable fuel line (Figure 5, Item 1 or Item 2) to elbow (Figure 5, Item 3 or Item 4).
10. Tighten fuel line (Figure 5, Item 1 or Item 2).
11. Connect battery (WP 0053, Reconnect).
12. Start refrigeration unit using diesel engine mode (TM 10-8415-222-10, Operating Procedures).
13. Check replaced elbow (Figure 5, Item 3 or Item 4) for leakage and repair if necessary per this WP.
14. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
0058-16
