TM 10-8145-222-23
0095
MAINTENANCE FUNCTIONS
Maintenance functions are limited to and defined as follows:
1. Inspect. To determine the serviceability of an item by comparing its physical, mechanical, and/or electrical
characteristics with established standards through examination (e.g., by sight, sound, or feel). This includes
scheduled inspection and gaugings and evaluation of cannon tubes.
2. Test. To verify serviceability by measuring the mechanical, pneumatic, hydraulic, or electrical characteristics of
an item and comparing those characteristics with prescribed standards on a scheduled basis, i.e., load testing
of lift devices and hydrostatic testing of pressure hoses.
3. Service. Operations required periodically to keep an item in proper operating condition; e.g., to clean (includes
decontaminate, when required), to preserve, to drain, to paint, or to replenish fuel, lubricants, chemical fluids, or
gases. This includes scheduled exercising and purging of recoil mechanisms. The following are examples of
service functions:
a.
Unpack. To remove from packing box for service or when required for the performance of maintenance
operations.
b.
Repack. To return item to packing box after service and other maintenance operations.
c.
Clean. To rid the item of contamination.
d.
Touch up. To spot paint scratched or blistered surfaces.
e.
Mark. To restore obliterated identification.
4. Adjust. To maintain or regulate, within prescribed limits, by bringing into proper position, or by setting the
operating characteristics to specified parameters.
5. Align. To adjust specified variable elements of an item to bring about optimum or desired performance.
6. Calibrate. To determine and cause corrections to be made or to be adjusted on instruments of test, measuring,
and diagnostic equipment used in precision measurement. Consists of comparisons of two instruments, one of
which is a certified standard of known accuracy, to detect and adjust any discrepancy in the accuracy of the
instrument being compared.
7. Remove/Install. To remove and install the same item when required to perform service or other maintenance
functions. Install may be the act of emplacing, seating, or fixing into position a spare, repair part, or module
(component or assembly) in a manner to allow the proper functioning of an equipment or system.
8. Paint (ammunition only). To prepare and spray color coats of paint so that the ammunition can be identified and
protected. The color indicating primary use is applied, preferably, to the entire exterior surface as the
background color of the item. Other markings are to be repainted as original so as to retain proper ammunition
identification.
9. Replace. To remove an unserviceable item and install a serviceable counterpart in its place "Replace" is
authorized by the MAC and assigned maintenance level is shown as the third position code of the Source,
Maintenance and Recoverability (SMR) code.
10. Repair. The application of maintenance services, including fault location/troubleshooting, removal/installation,
disassembly/assembly procedures and maintenance actions to identify troubles and restore serviceability to an
item by correcting specific damage, fault, malfunction, or failure in a part, subassembly, module (component or
assembly), end item, or system.
0095-2
