Section II. MOVEMENT TO NEW WORKSITE

TM 5-4120-273-15

BLOCK OFF PLATE:

STEP 1 - REMOVE COVER PLATE FROM BLOCK OFF PLATE AND

INSTALL ELECTRICAL CONNECTOR FROM REAR,

SECURE WITH SCREWS (4).

STEP 2 - REPLACE CONTROL BOX WITH BLOCK OFF PLATE AND

SECURE WITH SCREWS (4).

MEC 4120-273-15/2-1

Figure 21 (3)Continued

Section II. MOVEMENT TO NEW WORKSITE

(3) Unbolt unit from mounting surface.

2-7. Dismantling For Movement

a. General.

b. Short distance movement. Use a forklift and

(1) Shut off electrical power supply to air

lift unit at base.

conditioner and disconnect power cable from unit.

c. Long distance movement. Crate the air con-

(2) Disconnect drain hose from unit.

ditioner, providing adequate protection to grilles

Note. Disconnect all duct work and remote control

cable if used with unit.

and control box. Refer to TM 38-250 for instruc-

2-4