Figure 2-1. Block off plate.

Figure 2-1. Block off plate.

2-3. Installation or Setting Up Instructions

unobstructed to permit maximum unit capacity.

a. General. Set air conditioner in a level position

Condenser air enters and leaves the rear of the unit.

to allow proper condensate draining (operation will

NOTE

be satisfactory with the unit setting at a slight

Remove discharge and intake air grilles and air filter.

angle, not exceeding 5 , and using one of the four

if the unit is to be used with ducts carrying air to and

alternate drain connections).

from the conditioned space. Install grilles ond filter in

the duct. If a chemical nnd biological filter unit is to

b. Locating the Unit. The front access panel,

be attached to the unit remove the CBR cover (fig. 1-

discharge and intake air grilles are removable for

2 ).

n o r m a l service and maintenance and must be

2-2