CONDENSER FAN, MOTOR, AND HOUSING.-Continued

TM5-4120-383-14

4-36.

CONDENSER FAN, MOTOR, AND HOUSING.-Continued

(2) Carefully place condenser fan housing in unit by rotating

housing 90 counterclockwise and sliding into place.

(3) Secure condenser fan housing to unit with five attaching

screws.

(4) Install louver assembly and secure with four screws and

lock washers, and two screw snaps (para 4-17).

(5) Install condenser air inlet guard and secure with eight

screws and lock washers (para 4-12).

(6) Slide push-pull control cable through condenser fan

housing bracket, casing nut, and into mechanical post on louver

assembly connecting link.

(7) Tighten casing nut to secure push-pull control assembly

to condenser fan housing bracket.

adjustment before tightening screw in mechanical post.

(8) Secure push-pull control cable assembly to side of

condenser fan housing with screw, lock washer and loop clamp.

(9) Secure charging valves, pressure relief valve, and

refrigeration tubing to condenser fan housing with three loop

clamps, screws, washers, and lock washers.

(10)

Install fan inlet ring and secure with three screws and

washers.

(11) Slide motor shaft extension into hub of impeller fan and

secure with setscrew.

After bringing motor mounting bolts up snug, tighten

one full turn on each of the four bolts to compress

grommets flange by .06 inches.

(12) Insert four bushings and grommets into four motor

mounting holes and attach motor to mounting plate with eight flat

washers, four lock washers, and four cap screws.

(13)

Carefully place motor and mounting plate down into unit

and align holes in motor mounting plate with those in unit.

(14)

Install four cap screws and washers in motor mounting

plate but do not tighten them all the way.

4-102