|
|
TM5-4120-384-14
2 - 6 . OPERATIONAL CHECKS.-Continued
The
Turn the MODE SELECTOR switch to VENT (ventilate).
g.
Use a paper streamer or
evaporator fan should start immediately.
other method to check the airflow into the return air louver and
out of the conditioned air supply louver.
To check maximum ventilation with fresh air, first turn the
h.
fresh air damper control wheel to fully open (down) then adjust the
louvers in both sections of the return air louver fully closed.
Check the fresh air inlet located on the lower left corner of the
back of the unit using a paper streamer or other method to be sure
that air is being drawn in.
NOTE
For maximum ventilation with fresh air, it is
necessary that room or enclosure air have a means of
If the room or
exit through an open door or window.
enclosure is tightly closed, an overpressure will
build up and decrease the volume of fresh air drawn
in.
Fully
open
the
return
air
louvers
and
fully
close
the
fresh
i.
air damper.
Turn the TEMPERATURE SELECTOR (thermostat) knob to the full
j.
Then turn the MODE SELECTOR switch to
WARMER (clockwise) position.
Place your hand in the airflow from the conditioned air
LOW HEAT.
When the supply air
supply louver and feel for a temperature rise.
temperature has reached a relatively stable level, turn the MODE
SELECTOR switch to HIGH HEAT and feel for a further temperature
Next, turn the TEMPERATURE SELECTOR thermostat control knob
rise.
Feel that supply
to the fully COOLER (counterclockwise) position.
air temperature drops to approximately the same relatively stable
Finally, turn the MODE
level previously noted in LOW HEAT.
SELECTOR switch to LOW HEAT and feel the discharge air temperature
drop to ambient level (room temperature).
NOTE
The temperature thermostat control has an effective
functional range between 60F and 90F (16C and
32C).
In extreme conditions when ambient air
temperature is below 60F (16C) or above 90F
(32C), the operation in either LOW HEAT or HIGH HEAT
mode will vary from that described above.
2-10
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |