CONDENSER FAN, MOTOR, AND HOUSIING. (Cont)

TM5-4120-384-14

4-35.

CONDENSER FAN, MOTOR, AND HOUSING.-Continued

NOTE

The impeller fan and condenser fan housing must be

removed together as follows.

(13)

Remove

four

screws and

bell

inlet.

Use

care

not

break refrigeration

tubing.

(14) Remove four screws, lock washers, washers, and loop

clamps that secure charging valves, pressure relief valve, and

tubing to condenser fan housing.

(15) Remove seven screws, lock washers,

screw

snap,

and

condenser air inlet guard (para 4-12).

lock

washers,

two

screw

snaps,

and

(16) Remove five screws,

louver assembly (para 4-17).

(17) Remove seven screws attaching condenser fan housing to

The

Six screws are accessible from underneath the unit.

unit.

remaining screw is located on top of housing and secures condenser

fan housing to unit by means of a bracket.

(18) Carefully remove condenser fan

housing (with fan inside)

rotating housing 90 counterclockwise

and pulling straight out.

(19)

Separate

impeller

fan

from

condenser

fan

housing.

Replace

all

defective

components

found

during

Replace.

inspection and test.

Installation/Assembly.

(1)

Place

impeller

fan

condenser

fan

housing.

(2) Carefully place condenser fan housing in unit

rotating

housing 90 counterclockwise and sliding into place.

(3)

Secure

condenser

fan

housing

unit

with

seven

attaching

screws.

(4)

Install louver

assembly and secure

with

five

screws,

lock

washers,

and two screw

snaps (para 4-17).

(5) Install condenser air inlet guard and secure

with

seven

screws, lock washers, and screw snap (para 4-12).

4-104