TM 10-8145-222-23
0044
REPLACE CONTINUED
NOTE
There are two emergency escape hatches located in the container, one for each
MTRCS compartment. When the partition panels are installed in the MTRCS
container to separate the two compartments, compartment 1 access from
compartment 2 and compartment 2 access from compartment 1 will not be possible.
8. Tag and disconnect evaporator electrical connector (Figure 2, Item 1) from evaporator (Figure 2, Item 2).
WARNING
Make sure the evaporator cover is stabilized with your hand prior to removal of the
bolts. Failure to do so can cause injury or death.
9. Remove two bolts (Figure 2, Item 3), lock washers (Figure 2, Item 8), and washers (Figure 2, Item 4) securing
evaporator cover (Figure 2, Item 5) closed. Discard lock washers. Allow evaporator cover (Figure 2, Item 5) to
swing down while securing with one hand.
WARNING
Do not touch capacitor terminals for the first five minutes after the power has been
disconnected. Capacitors can store electrical power for extended periods of time after
being disconnected from power supply. Failure to comply can cause serious personal
injury or death.
10. Cut wire ties securing capacitor wiring (Figure 2, Item 6) using care not to cut wires.
11. Tag and disconnect capacitor wiring (Figure 2, Item 6) and unscrew capacitor (Figure 2, Item 7).
12. Install new capacitor (Figure 2, Item 7) and reconnect wiring (Figure 2, Item 6) as tagged.
13. Secure capacitor wiring (Figure 2, Item 6) with wire ties.
14. Close evaporator cover (Figure 2, Item 5) and secure with two bolts (Figure 2, Item 3), new lock washers
(Figure 2, Item 8), and washers (Figure 2, Item 4).
15. Reconnect evaporator electrical connector (Figure 2, Item 1) to evaporator (Figure 2, Item 2).
16. Connect battery (-) negative terminal (WP 0053, Reconnect).
17. Open MTRCS control box door (Figure 1, Item 1).
18. On control box, place COMPARTMENT 1 ON/OFF rocker switch (Figure 1, Item 2) to ON position.
19. Place COMPARTMENT 2 ON/OFF rocker switch (Figure 1, Item 3) to ON position.
20. Place POWER ON/DOWN switch (Figure 1, Item 4) on control panel to ON position.
21. Close MTRCS control box door (Figure 1, Item 1) and latch (Figure 1, Item 5).
0044-3
