TM 10-8145-222-23
0052
REPLACE CONTINUED
NOTE
The cord mesh surrounding the cable can be easily maneuvered and slid up or down
the cable by compressing the mesh.
14. Slide cord mesh (Figure 11, Item 12) over cable assembly (Figure 11, Item 10) and into power box (Figure 11,
Item 4).
15. Install lock nut (Figure 11, Item 11) and tighten to secure cable assembly P2A (Figure 11, Item 10) to power box
(Figure 11, Item 4).
16. Install tie-down straps at locations where removed to secure installation.
17. Close and secure power box door (Figure 11, Item 1).
18. Reconnect battery negative (-) terminal (WP 0053, Reconnect).
19. Perform Test Cable Assembly P2A in accordance with this WP.
20. Place cable assembly P1A (Figure 8, Item 1) and P2A (Figure 8, Item 2) on storage hooks (Figure 8, Item 3 and
Item 4).
21. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
END OF TASK
END OF WORK PACKAGE
0052-19/20 blank