TM 10-8145-222-23
0056
REPAIR
Replace Lid Gaskets
1. Open document holder lid (Figure 1, Item 5).
2. Remove damaged gasket (Figure 1, Item 6) from lid using scraper.
3. Using bulk rubber strip, make five new gasket strips to approximate lengths and widths required on each non-
hinged side of lid interior.
WARNING
Wear protective gloves and eye protection when using Isopropyl alcohol. If contact
with eyes is made, flush with clean water and seek immediate medical first aid for
eyes. Rinse and dry hands immediately after exposure. Failure to observe this
warning may result in drying and/or serious damage to the skin.
4. Clean gasket surface area of lid with isopropyl alcohol.
WARNING
Always wear eye, face, and hand protection when working with adhesives. Avoid
contact with skin and clothes and do not breathe vapors. If contact is made with eyes
or skin, seek immediate medical aid.
5. Apply small quantity of adhesive to entire length of gasket (Figure 1, Item 6) and install on lid (Figure 1, Item 5).
6. Press gasket (Figure 1, Item 6) firmly in place and clean any excess adhesive that may seep from under
gasket.
7. Allow adhesive to cure.
8. Close document holder lid (Figure 1, Item 5).
Replace Draw-Pull Catch
1. Open document holder lid (Figure 1, Item 5).
WARNING
Wear eye protection when drilling old rivets out. Rivet chips can be hot and fly in
various directions.
2. Drill two rivets (Figure 1, Item 7) out of document holder lid (Figure 1, Item 5) and remove draw (Figure 1,
Item 8) of draw-pull catch.
3. Drill two rivets (Figure 1, Item 9) out of top of document holder (Figure 1, Item 4) and remove pull (Figure 1,
Item 10) of draw-pull catch.
0056-3
