TM 10-8145-222-23
0066
REPLACE CONTINUED
NOTE
Rear side of saddle clamp will stay in place until both saddle clamps have been
removed. Both saddle clamps mount the same way. Figure 1 is used as a visual
reference for both saddle clamps.
7. Remove front side of saddle clamp and spacer (Figure 1, Item 4).
8. Remove two bolts (Figure 1, Item 6), washers (Figure 1, Item 7), and nuts (Figure 1, Item 8) securing suction
tube saddle clamp and spacer (Figure 1, Item 9) located near suction service valve (Figure 1, Item 10).
NOTE
Be sure to note position of old valve before desoldering so that new valve can be
installed with correct orientation.
9. Remove one screw (Figure 1, Item 11), lock washer (Figure 1, Item 12), washer (Figure 1, Item 13), and nut
(Figure 1, Item 14) securing CPR valve clamp (Figure 1, Item 15) to clamp mounting plate. Discard lock washer.
10. Remove clamp (Figure 1, Item 15) from CPR valve (Figure 1, Item 5).
11. Remove four bolts (Figure 1, Item 16) and four washers (Figure 1, Item 17) securing suction service valve
(Figure 1, Item 10) to compressor.
12. Remove suction service valve (Figure 1, Item 10) and gasket (Figure 1, Item 18) from compressor.
13. Discard gasket (Figure 1, Item 18).
14. Remove rear side of saddle clamps (Figure 1, Item 19 and Item 20).
15. Remove four bolts (Figure 2, Item 2), and four washers (Figure 2, Item 3), and two nuts (Figure 2, Item 4), two
washers (Figure 2, Item 5), and two bolts (Figure 2, Item 6) securing support arm (Figure 2, Item 1) to frame
above accumulator, and support arm bracket (Figure 2, Item 7) to support arm (Figure 2, Item 1).
16. Remove support arm (Figure 2, Item 1).
0066-3
