TM 10-8145-222-23
0068
REPLACE CONTINUED
Install
WARNING
The condenser assembly weighs approximately 40 pounds and is a bulky item. Use
two persons to install the condenser assembly into the refrigeration unit.
1. Carefully install replacement condenser assembly into refrigeration unit.
NOTE
There are four hex head bolts that secure the base of the condenser assembly to the
refrigeration unit frame. There are two bolts on each end of the condenser assembly
and they are installed from the underside of the frame.
2. Secure base of condenser assembly (Figure 10, Item 2) to frame (Figure 10, Item 3) using four hex head bolts
(Figure 10, Item 1).
3. Install new gasket (Figure 9, Item 5) and secure discharge service valve (Figure 9, Item 3) to compressor
(Figure 9, Item 4) using two bolts (Figure 9, Item 1) and washers (Figure 9, Item 2).
WARNING
Soldering procedures emit gasses that can be harmful if inhaled for long durations.
Before performing any soldering procedures, make sure that adequate ventilation is
available. Use face shield and protective gloves when performing soldering
procedures.
CAUTION
Soldering and desoldering procedures take place in a very tight surrounding. Make
sure a heat shield is used during solder and desolder procedures to protect wiring
and associated components nearby.
4. Solder vertical refrigerant pipe running between radiator (Figure 8, Item 1) and accumulator (Figure 8, Item 2) at
soldered joint (Figure 8, Item 3).
5. Install main heat valve coil (Figure 7, Item 1) and secure using clip (Figure 7, Item 2).
6. Reconnect electrical connector to main heat valve coil (Figure 7, Item 1).
7. Install hot gas valve coil (Figure 7, Item 3) and secure using screw (Figure 7, Item 4).
8. Reconnect electrical connector to hot gas valve coil (Figure 7, Item 3).
9. Connect refrigeration pipe (Figure 6, Item 6) to filter-dryer (Figure 6, Item 8) inlet and secure using fitting
(Figure 6, Item 15).
10. Install two clamps (Figure 6, Item 13) to two refrigerant pipes (Figure 6, Item 7 and Item 14) near filter-drier
(Figure 6, Item 8) inlet and secure using one screw (Figure 6, Item 9), nut (Figure 6, Item 10), lock washer
(Figure 6, Item 11), and washer (Figure 6, Item 12).
0068-13
