TM 10-8145-222-23
0029
REPLACE CONTINUED
11. Tag and disconnect starter pigtail connector (Figure 3, Item 7) from engine wire harness (Figure 3, Item 16).
NOTE
White lead coming off of starter is not used.
12. Remove two bolts (Figure 3, Item 12), lock washers (Figure 3, Item 13), and washers (Figure 3, Item 14)
securing starter (Figure 3, Item 6) to engine block (Figure 3, Item 9). Discard lock washers.
13. Remove starter (Figure 3, Item 6).
14. Remove one nut (Figure 3, Item 10) and lock washer (Figure 3, Item 11) securing starter pigtail connector
(Figure 3, Item 8) to starter (Figure 3, Item 6). Retain pigtail connector for replacement starter.
15. Install starter pigtail connector (Figure 3, Item 8) to new starter (Figure 3, Item 6) using one nut (Figure 3,
Item 10) and new lock washer (Figure 3, Item 11).
16. Install new starter (Figure 3, Item 6) and secure using two bolts (Figure 3, Item 12), new lock washers (Figure 3,
Item 13), and washers (Figure 3, Item 14).
17. Tighten and torque bolts (Figure 3, Item 12) (WP 0091, Introduction).
18. Connect electrical connector (Figure 3, Item 15) to new starter (Figure 3, Item 6) as tagged. Remove tag.
19. Connect starter pigtail connector (Figure 3, Item 17) to engine wire harness (Figure 3, Item 16). Remove tag.
20. Connect positive lead (Figure 3, Item 5) to starter (Figure 3, Item 6) as tagged using nut (Figure 3, Item 1), new
lock washer (Figure 3, Item 2), and washer (Figure 3, Item 3).
21. Install top-right panel (WP 0013, Install).
22. Place emergency stop switch (Figure 2, Item 1) in PULL TO START position.
23. Climb off of MTRCS using roof access provided.
24. Reconnect battery negative (-) terminal (WP 0053, Reconnect).
25. Place POWER ON/DOWN switch (Figure 1, Item 2) on control panel to ON position.
26. Start refrigeration unit to verify proper operation (TM 10-8415-222-10, Operating Procedures).
27. Close control panel access door (Figure 1, Item 1).
28. If removed, install front panel assembly (WP 0013, Install)
29. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
END OF TASK
END OF WORK PACKAGE
0029-4
