TM 10-8145-222-23
0061
REPLACE CONTINUED
6. Partially remove alternator (WP 0030, Remove).
7. Tag and disconnect suction compressor discharge temperature sensor electrical connector (Figure 2, Item 1).
8. Tag and disconnect suction pressure transducer electrical connector (Figure 2, Item 2).
9. Tag and disconnect two high pressure cutout switch electrical connectors (Figure 2, Item 3).
10. Tag and disconnect unloader coil electrical connector (Figure 2, Item 4).
11. Frontseat (close) suction service valve (Figure 2, Item 5) by turning clockwise.
12. Frontseat (close) discharge service valve (Figure 2, Item 6) by turning clockwise.
13. Remove two bolts (Figure 2, Item 7) and washers (Figure 2, item 8) securing discharge service valve (Figure 2,
Item 6) to compressor (Figure 2, Item 9).
14. Remove discharge service valve (Figure 2, Item 6) and gasket (Figure 2, Item 10) from compressor (Figure 2,
Item 9) with piping attached. Discard gasket.
CAUTION
The discharge tube can kink or be easily bent if not careful. Use care when removing
or repositioning discharge service valve from compressor so that tube is not bent or
otherwise damaged during removal.
15. Carefully secure discharge service valve (Figure 2, Item 6) out of way.
16. Remove two bolts (Figure 2, Item 14), washers (Figure 2, Item 15), and nuts (Figure 2, Item 16) securing saddle
clamp (Figure 2, Item 17) to suction line (Figure 2, Item 18). Discard lock washers.
17. Remove saddle clamp (Figure 2, Item 17). Retain for reinstallation.
18. Remove four bolts (Figure 2, Item 12) and four washers (Figure 2, Item 13) securing suction service valve
(Figure 2, Item 5) to compressor (Figure 2, Item 9).
19. Remove suction service valve (Figure 2, Item 5) and gasket (Figure 2, Item 11) from compressor (Figure 2,
Item 9) with piping attached. Discard gasket.
CAUTION
The suction tube can kink or be easily bent if not careful. Use care when removing or
repositioning suction service valve from compressor so that tube is not bent or
otherwise damaged during removal.
20. Carefully secure suction service valve (Figure 2, Item 5) out of the way.
21. Remove standby motor to compressor V-belt (WP 0036, Remove).
0061-3
