TM 10-8145-222-23
0061
REPLACE CONTINUED
NOTE
The two forward mount bolts will pass through the spacers located between the
compressor and the power tray.
10. Secure front end of compressor to power tray using two bolts (Figure 3, Item 5), washers (Figure 3, Item 6),
new lock washers (Figure 3, Item 7), and nuts (Figure 3, Item 8).
11. Torque four compressor mount bolts (Figure 3, Item 1 and Item 5) to 40 foot-pounds (WP 0091).
12. Temporarily install engine but do not tighten (WP 0071, Install).
CAUTION
The suction and discharge tubes can kink or be easily bent if not careful. Use care
when installing suction and discharge service valves so that tubes are not bent or
otherwise damaged during installation.
NOTE
Always clean surface area of compressor prior to installing a new gasket.
13. Clean gasket area of suction and discharge service valve mount locations on compressor.
14. Reinstall discharge service valve (Figure 5, Item 6) and new gasket (Figure 5, Item 10) and secure using two
bolts (Figure 5, Item 7) and washers (Figure 5, Item 8). Torque bolts 20 to 30 foot-pounds (WP 0091).
15. Reinstall suction service valve (Figure 5, Item 5) and new gasket (Figure 5, Item 11) to compressor and secure
using four bolts (Figure 5, Item 12) and washers (Figure 5, Item 13). Torque bolts to 55 to 80 foot-pounds (WP
16. Install saddle clamp (Figure 5, Item 17) to suction line (Figure 5, Item 18) and secure using two bolts (Figure 5,
Item 14), washers (Figure 5, Item 15), and nuts (Figure 5, Item 16).
17. Tighten standby motor to compressor V-belts (WP 0035, Install).
18. Reinstall partially removed alternator (WP 0030, Install).
19. Check alternator V-belt tension (WP 0035, Adjust).
20. Reconnect two high pressure cutout switch electrical connectors (Figure 5, Item 3) as tagged.
21. Reconnect unloader coil electrical connector (Figure 5, Item 4) as tagged.
22. Reconnect pressure transducer electrical connector (Figure 5, Item 2) as tagged.
0061-8
