COMPRESSOR DIRECT SUPPORT MAINTENANCE REPLACEMENT

TM 9-4120-425-14&P

COMPRESSOR DIRECT SUPPORT MAINTENANCE REPLACEMENT

THIS WORK PACKAGE COVERS:

Test, Removal, Decontamination, Repair, and Installation

INITIAL SETUP:

Maintenance Level

Direct Support

Tools and Special Tools

Tool Kit, General Mechanics (Item 1, Table 2, WP 0118-00)

Tool Kit, Service, Refrigeration Unit (Item 2, Table 2, WP 0118-00)

Recovery and Recycle Unit, Refrigerant (Item 5, Table 2, WP 0118-00)

Lifting Device

Mask, Air Filtering (Item 29, Table 1, WP 0121-00)

Personnel Required

Two people needed for compressor removal and installation.

References

WP 0118-00 (MAC)

Equipment Condition

Mode selector switch in OFF position.

Main power source is disconnected.

Panels removed (WP 0019-00).

System refrigerant discharged (WP 0049-00).

Condenser motors and condenser impeller fans removed (WP 0062-00).

Condenser fan scrolls removed (WP 0063-00).

Condenser fan supports removed (WP 0064-00).

Damper actuator cylinder removed (WP 0068-00).

Test Equipment:

Multimeter

Materials/Parts

Nitrogen (Item 4 Table 1, WP 0121-00)

Brazing alloy (Item 5 or 6, Table 1, WP 0121-00)

Brazing flux (Item 7, Table 1, WP 0121-00)

Special Environmental Condition

NOTE

In accordance with Environmental Protection Agency regulations, refrigerants

cannot be discharged into the atmosphere. A refrigerant recovery and recycling unit

must be used whenever discharging the refrigerant system.

Operation of the recovery/recycling unit must be by AUTHORIZED PERSONNEL

ONLY.

0076-00-1