TM 10-8145-222-23
0039
REPLACE CONTINUED
NOTE
Make sure that the orientation of the rain cap is installed with the same orientation as
when it was removed.
17. Tighten nuts (Figure 4, Item 10).
18. Secure opposite end of muffler (Figure 4, Item 12) to engine in two places (Figure 4, Item 16) by tightening two
bolts (Figure 4, Item 14) and washers (Figure 4, Item 15).
19. Install replacement muffler pipe (Figure 4, Item 6) onto replacement muffler (Figure 4, Item 12) and secure
using replacement U-bolt (Figure 1, Item 9), clamp (Figure 4, Item 8), and two nuts (Figure 4, Item 7).
20. Tighten nuts (Figure 4, Item 7).
21. Reinstall muffler rain cap (Figure 4, Item 1).
22. Install top-right panel (WP 0013, Install).
23. Check that rain cap pivots freely with top-right panel installed.
24. Place emergency stop switch (Figure 2, Item 1) in PULL TO START position
WARNING
Falling from the top of the MTRCS can result in serious injury or death to personnel.
Whenever performing maintenance on top of the MTRCS, always maintain three
points of contact to aid in stability. Never attempt to walk backwards while on top of
the container.
25. Climb off top of MTRCS using roof access.
26. Reconnect battery negative (-) terminal (WP 0053, Reconnect).
27. Place POWER ON/DOWN switch (Figure 1, Item 2) on control panel to ON position.
28. Close control panel access cover (Figure 1, Item 1)
29. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
END OF TASK
END OF WORK PACKAGE
0039-8
