TM 10-8145-222-23
0076
REPLACE CONTINUED
20. Install alternator (WP 0030, Install).
CAUTION
Overtightening of nuts on studs will cause damage to the alternator.
21. Using tags on wiring leads (Figure 6, Item 1 and Item 2) to identify connection points, connect wiring leads
(Figure 6, Item 1 and Item 2) to back of alternator (Figure 6, Item 3).
22. Install alternator V-belt (WP 0035, Install).
23. Reconnect electrical wiring (Figure 6, Item 10) to standby motor (Figure 6, Item 11) as tagged.
24. Install standby motor electrical wiring cover (Figure 6, Item 12) to standby motor and secure using four screws
(Figure 6, Item 13) and washers (Figure 6, Item 14).
25. Perform alignment of diesel engine, compressor, and standby motor belts per this Work Package.
26. Install refrigeration unit (WP 0059, Install).
27. Place emergency stop switch in PULL TO START position.
28. Exit top of MTRCS using roof access.
29. Perform Operation Under Usual Conditions (TM 10-8415-222-10, Operating Procedures).
30. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
0076-13