TM 10-8145-222-23
0077
REPLACE CONTINUED
Install
CAUTION
The radiator coils damage easily. In order to install the standby motor, the fan will
have to rest inside the radiator housing against the coils until the standby motor is
removed. Use extreme care so as not to damage the radiator coils.
1. Clean condenser coil (WP 0021, Service).
2. Attach hoist to replacement standby motor eye bolt (Figure 5, Item 8) and lower into place on motor bracket
(Figure 5, Item 7).
3. Secure standby motor (Figure 5, Item 6) to motor bracket (Figure 5, Item 7) by installing four bolts (Figure 5,
Item 2), washers (Figure 5, Item 3), and new lock nuts (Figure 5, Item 5).
CAUTION
The radiator coils damage easily. In order to reinstall the standby motor, the
condenser fan will have to rest inside the radiator housing against the coils until the
standby motor is in place and the fan is ready to be reattached to the standby motor
shaft. Use extreme care so as not to damage the radiator coils.
4. Using hoist, lift standby motor assembly (Figure 6, Item 11) and carefully lower into place on refrigeration unit
chassis so that right and left motor bracket holes align with chassis holes. Do not install mounting hardware at
this time.
5. Make sure condenser fan (Figure 6, Item 3) is in radiator housing resting carefully against coils before installing
standby motor assembly (Figure 5, Item 1).
6. Reinstall machine key (Figure 6, Item 4) to standby motor shaft (Figure 6, Item 10).
0077-10
