TM 10-8145-222-23
0079
REPAIR CONTINUED
NOTE
The 8 10mm nuts must be tightened in the following pattern to avoid board pressure that could damage
circuitry. Do not over-tighten the nuts.
7
4
5
1
2
6
8
3
Figure 14. Bolt Tightening Pattern.
9. Secure MPC board (Figure 17, Item 8) to EMI box (Figure 17, Item 5) with eight washers (Figure 17, Item 10)
and nuts (Figure 17, Item 9).
10. Connect connector P2 (Figure 17, Item 7) to MPC board (Figure 17, Item 8) and secure with electrical tape.
Reconnect the negative (-) battery terminal (WP 70, Reconnect).