TM 10-8145-222-23
0019
REPLACE CONTINUED
Figure 2. HP1 and HP2.
NOTE
It is necessary to verify replacement cutout switch settings before installing it.
Perform the high pressure switch test in accordance with instruction provided in this
WP before installing the switch.
10. Perform high pressure cutout switch test on new HP1 and HP2 in accordance with Test paragraph in this WP.
11. Install tested switch HP1 (Figure 2, Item 6) into tee (Figure 2, Item 4) and tighten 1/4-turn past hand tight.
12. Install tested switch HP2 (Figure 2, Item 2) into elbow (Figure 2, Item 3) and tighten 1/4-turn past hand tight.