TM 10-8145-222-23
0051
REPLACE CONTINUED
Install Wall Mounted Light Strip Lamp Assemblies
1. Install new white light lamp assembly (Figure 1, Item 7) onto container wall and secure using two screws
(Figure 1, Item 10) and new lock washers (Figure 1, Item 11).
2. Connect power source electrical connector (Figure 1, Item 9) to white light strip lamp assembly (Figure 1,
Item 7) electrical connector (Figure 1, Item 8).
3. Install new red light lamp assembly (Figure 1, Item 3) onto container wall and secure using two screws
(Figure 1, Item 5) and threaded standoffs (Figure 1, Item 6).
4. Prepare existing wiring and wiring on new red light strip lamp assembly (Figure 1, Item 3) for splicing.
5. Reconnect wiring (Figure 3, Item 12) by installing two splices onto wiring on new red light strip lamp assembly
(Figure 1, Item 3) and container wiring at splice points (Figure 1, Item 4) as tagged, and remove tags.
6. Reinstall protective covering over applicable red light strip lamp assembly (Figure 1, Item 3).
7. Reconnect battery (WP 0053, Reconnect).
8. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
Remove Multi-light Assembly
NOTE
Once the cover of the multi-light assembly is removed, the cover and wiring for lights
will hang freely. The entire cover, with lights and associated wiring attached, will be
removed and replaced as a part of this procedure.
The cover can be easily removed by pinching the base in and pulling the cover off in
a repeated motion for the entire length of the cover.
1. Pry multi-light assembly cover (Figure 1, Item 13) off by starting at one end and working cover off towards
opposite end, and allow assembly to hang freely.
2. Tag and cut wiring for multi-light assembly (Figure 1, Item 14) at four splice points (Figure 1, Item 15) at
evaporator end of assembly and remove multi-light assembly (Figure 1, Item 14).
Install Multi-Light Assembly
1. Prepare existing wiring and wiring on new multi-light assembly (Figure 1, Item 14) for splicing.
2. Reconnect wiring by installing four splices onto wiring on new multi-light assembly (Figure 1, Item 14) and
container wiring at splice points (Figure 1, Item 15) as tagged, and remove tags.
NOTE
When installing the cover over the track base, it is important to make sure that all
wiring is tucked inside of track so it is not pinched.
3. Install multi-light assembly cover (Figure 1, Item 13) by starting at one end and working cover on towards
opposite end.
0051-3
