TM 10-8145-222-23
0051
REPLACE CONTINUED
Remove Multi-Light Assembly White LED Light Strip LT3.
NOTE
Once the cover of the multi-light assembly is removed, the cover and wiring for lights
will hang freely.
The cover can be easily removed by pinching the base in and pulling the cover off in
a repeated motion for the entire length of the cover.
1. Remove two end caps (Figure 2, Item 1 and Item 2) from both ends of multi-light assembly channel (Figure 2,
Item 3).
2. Slide end cap (Figure 2, Item 1) and grommet (Figure 2, Item 4) up along wire harness (Figure 2, Item 5).
3. Pry multi-light assembly cover (Figure 2, Item 6) off by starting at one end and working cover off towards
opposite end, and allow assembly to hang freely.
NOTE
When cutting splices, always cut wires as close to the splice as possible in order to
leave as much wire left as possible for re-splicing.
4. Remove tie wraps as needed to gain access to light strip splice points.
5. On forward end of white LED light strip LT3 (Figure 2, Item 7), tag and then cut one red wire from one brown
wire directly behind splice (Figure 2, Item 8). Discard splice.
6. Tag and then cut one black wire from one blue wire directly behind splice (Figure 2, Item 8). Discard splice.
7. On aft end of white LED light strip LT3 (Figure 2, Item 7), tag and then cut one blue wire from one white wire
directly behind splice (Figure 2, Item 9). Discard splice.
8. Tag and then cut one brown wire from one white wire directly behind splice (Figure 2, Item 9). Discard splice.
9. Remove two screws (Figure 2, Item 11), lock washers (Figure 2, Item 12), and washers (Figure 2, Item 13)
securing white LED light strip LT3 (Figure 2, Item 7) to multi-light assembly cover (Figure 2, Item 6).
10. Pull wires through cutout in multi-light assembly cover (Figure 2, Item 6) and remove white LED light strip LT3
(Figure 2, Item 7) from multi-light assembly cover (Figure 2, Item 6).
0051-4
