TM 10-8145-222-23
0051
REPLACE CONTINUED
Install Multi-Light Assembly Red LED Light Strip BLT3.
1. On replacement red LED light strip BLT3 (Figure 5, Item 14), cut wires leaving approximately 6-inches of wire
on end of light strip.
2. Prepare existing container wiring and wiring on replacement LED light strip BLT3 (Figure 5, Item 14) for
splicing.
3. Route wires through cutout in multi-light assembly cover (Figure 5, Item 6) and secure red LED light strip BLT3
(Figure 5, Item 14) to multi-light assembly cover (Figure 5, Item 6) using two screws (Figure 5, Item 16).
4. On replacement red LED light strip BLT3 (Figure 5, Item 14), connect one white wire to one white wire as
tagged using splice (Figure 5, Item 15). Remove tags.
5. Connect one green wire to one white wire as tagged using splice (Figure 5, Item 15). Remove tags.
6. Install tie wraps as needed to secure light strip wiring.
NOTE
When installing the cover over the track base, it is important to make sure that all
wiring is tucked inside of track so it is not pinched.
7. Install multi-light assembly cover (Figure 5, Item 6) by starting at one end and working cover on towards
opposite end.
8. Install two end caps (Figure 5, Item 1 and Item 2) over both ends of multi-light assembly channel (Figure 5,
Item 3).
9. Press grommet (Figure 5, Item 4) in place in end cap (Figure 5, Item 1) and over wires (Figure 5, Item 5).
0051-9
