TM 10-8145-222-23
0051
REPLACE CONTINUED
Figure 5. Installation of Red BLT3 Light Strip.
Remove Multi-Light Assembly White LED Light Strip LT4.
NOTE
Once the cover of the multi-light assembly is removed, the cover and wiring for lights
will hang freely.
The cover can be easily removed by pinching the base in and pulling the cover off in
a repeated motion for the entire length of the cover.
1. Remove two end caps (Figure 6, Item 1 and Item 2) from both ends of multi-light assembly channel (Figure 6,
Item 3).
2. Slide end cap (Figure 6, Item 1) and grommet (Figure 6, Item 4) up along wire harness (Figure 6, Item 5).
3. Pry multi-light assembly cover (Figure 6, Item 6) off by starting at one end and working cover off towards
opposite end; allow assembly to hang freely.
