TM 10-8145-222-23
0051
REPLACE CONTINUED
Install Multi-Light Assembly White LED Light Strip LT3.
NOTE
Replacement white LED light strips will come with connectors attached on each end.
It will be necessary to cut the connectors off of the replacement light strip. Once the
connectors are cut off, the white insulation protecting the two individual wires on each
end will need to be stripped back approximately 2-inches in order to prepare the
individual wires for splicing.
1. On replacement white LED light strip LT3 (Figure 3, Item 7), cut electrical connectors off of each end of light
strip leaving approximately 6-inches of wire on each end of light strip.
2. Trim white insulation back approximately 3-inches to expose two individual light strip wires on each end where
cut.
3. Prepare existing container wiring and wiring on replacement LED light strip LT3 (Figure 3, Item 7) for splicing.
4. Route wires through cutout in multi-light assembly cover (Figure 3, Item 6) and secure white LED light strip LT3
(Figure 3, Item 7) to multi-light assembly cover (Figure 3, Item 6) using two screws (Figure 3, Item 11), lock
washers (Figure 3, Item 12), and washers (Figure 3, Item 13).
5. On aft end of white LED light strip LT3 (Figure 3, Item 7), connect one brown wire to one white wire as tagged
using splice (Figure 3, Item 9). Remove tags.
6. Connect one blue wire to one white wire as tagged using splice (Figure 3, Item 9). Remove tags.
7. On forward end of white LED light strip LT3 (Figure 3, Item 7), connect one blue wire to one black wire as
tagged using splice (Figure 3, Item 8).
8. Connect one brown wire to one red wire as tagged using splice (Figure 3, Item 8).
9. Install tie wraps as needed to secure light strip wiring.
NOTE
When installing the cover over the track base, it is important to make sure that all
wiring is tucked inside of track so it is not pinched.
10. Install multi-light assembly cover (Figure 3, Item 6) by starting at one end and working cover on towards
opposite end.
0051-6
