TM 10-8145-222-23
0051
REPLACE CONTINUED
Figure 3. Installation of White LT3 Light Strip.
11. Install two end caps (Figure 3, Item 1 and Item 2) over both ends of multi-light assembly channel (Figure 3,
Item 3).
12. Press grommet (Figure 3, Item 4) in place in end cap (Figure 3, Item 1) and over wires (Figure 3, Item 5).
Remove Multi-Light Assembly Red LED Light Strip BLT3.
NOTE
Once the cover of the multi-light assembly is removed, the cover and wiring for lights
will hang freely.
The cover can be easily removed by pinching the base in and pulling the cover off in
a repeated motion for the entire length of the cover.
1. Remove two end caps (Figure 4, Item 1 and Item 2) from both ends of multi-light assembly channel (Figure 4,
Item 3).
2. Slide end cap (Figure 4, Item 1) and grommet (Figure 4, Item 4) up along wire harness (Figure 4, Item 5).