TM 10-8145-222-23
0051
REPLACE CONTINUED
Install Multi-Light Assembly White LED Light Strip LT4.
NOTE
Replacement white LED light strips will come with connectors attached on each end.
It will be necessary to cut the connectors off of the replacement light strip. Once the
connectors are cut off, the white insulation protecting the two individual wires on each
end will need to be stripped back approximately 2-inches in order to prepare the
individual wires for splicing.
1. On replacement white LED light strip LT4 (Figure 7, Item 17), cut electrical connectors off of each end of light
strip leaving approximately 6-inches of wire on each end of light strip.
2. On forward side of white LED light strip LT4 (Figure 7, Item 17), trim white insulation back approximately
3-inches to expose two individual light strip wires where cut.
3. Prepare existing container wiring and wiring on forward end of replacement white LED light strip LT4 (Figure 7,
Item 17) for splicing.
4. Route wires through cutout in multi-light assembly cover (Figure 7, Item 6) and secure white LED light strip LT4
(Figure 7, Item 17) to multi-light assembly cover (Figure 7, Item 6) using two screws (Figure 7, Item 21), lock
washers (Figure 7, Item 22), and washers (Figure 7, Item 23).
NOTE
The aft end of the white LED light strip LT4 will be dead-ended. This can be done
using approximately 1 1/2-inches of heat shrink insulation sleeve over the end of the
harness with approximately half on the harness and half extending past the harness
ending.
5. On aft end of white LED light strip LT4 (Figure 7, Item 7), install approximately 1 1/2-inches of insulation sleeve
(Figure 7, Item 19) over cut harness and heat shrink in place using heat gun.
6. On forward end of white LED light strip LT4 (Figure 7, Item 17), connect one blue wire to one white wire as
tagged using splice (Figure 7, Item 18).
7. Connect one brown wire to one white wire as tagged using splice (Figure 7, Item 18).
8. Install tie wraps as needed to secure light strip wiring.
NOTE
When installing the cover over the track base, it is important to make sure that all
wiring is tucked inside of track so it is not pinched.
9. Install multi-light assembly cover (Figure 7, Item 6) by starting at one end and working cover on towards
opposite end.
10. Install two end caps (Figure 7, Item 1 and Item 2) over both ends of multi-light assembly channel (Figure 7,
Item 6).
11. Press grommet (Figure 7, Item 4) in place in end cap (Figure 7, Item 1) and over wires (Figure 7, Item 5).
0051-12
