TM 10-8145-222-23
0051
REPLACE CONTINUED
Figure 4. Removal of Red BLT3 Light Strip.
3. Pry multi-light assembly cover (Figure 4, Item 6) off by starting at one end and working cover off towards
opposite end, and allow assembly to hang freely.
NOTE
When cutting splices, always cut wires as close to the splice as possible in order to
leave as much wire left as possible for re-splicing.
4. Remove tie wraps as needed to gain access to light strip splice points.
5. On red LED light strip BLT3 (Figure 4, Item 14), tag and then cut one white wire from one green wire directly
behind splice (Figure 4, Item 15). Discard splice.
6. Tag and then cut one white wire from one white wire directly behind splice (Figure 4, Item 15). Discard splice.
7. Remove two screws (Figure 4, Item 11) securing red LED light strip BLT3 (Figure 4, Item 14) to multi-light
assembly cover (Figure 4, Item 6).
8. Pull wires through cutout in multi-light assembly cover (Figure 4, Item 6) and remove red LED light strip BLT3
(Figure 4, Item 14) from multi-light assembly cover (Figure 4, Item 6).