TM 10-8145-222-23
0071
REPLACE CONTINUED
Install
Install the refrigeration unit diesel engine as follows:
1. Record engine identification number (serial number) of new engine.
2. On MTRCS01 only, install speed solenoid (WP 0042, Install).
3. Install run solenoid (WP 0041, Install).
4. Install oil pressure switch (WP 0040, Install).
5. Install water temperature sensor (WP 0027, Install).
WARNING
Never perform a lifting operation alone and always use guide ropes when using a
hoist and moving hanging assemblies.
A lack of attention or improper positioning during a lifting operation can cause serious
injury or death. Pay very close attention at all times to items being moved during a lift
operation. Never stand under an item being lifted or in a position where you could be
trapped or pinned.
6. Attach hoist to engine at two engine hoist points (Figure 12, Item 17).
NOTE
The inboard and outboard engine mount brackets are secured to the engine with
eight bolts, lock washers, and washers on each side.
7. Attach inboard engine mount bracket (Figure 12, Item 4) and outboard engine mount bracket (Figure 12, Item 5)
to engine using 16 bolts (Figure 12, Item 12), new lock washers (Figure 12, Item 13), and washers (Figure 12,
Item 14). Leave inboard bolts loose at this time.
8. Torque eight outboard mount bracket bolts (Figure 12, Item 12) to 40 foot-pounds (WP 0091).
NOTE
The inboard engine mount bracket is kept loose while lowering the engine into place.
During installation of engine into the refrigeration unit chassis, it will be necessary to
maneuver the inboard engine mount bracket in order to fit the engine into place.
9. Lift engine using hoist and lower onto refrigeration unit chassis.
0071-14
