TM 10-8145-222-23
0033
TEST CONTINUED
5. Place emergency stop switch (Figure 2, Item 1) in PUSH TO STOP position.
Figure 2. Emergency Stop Switch.
6. Remove three nuts (Figure 3, Item 1) securing glow plug lead assembly (Figure 3, Item 2) to three glow plugs
(Figure 3, Item 3).
7. Disconnect electrical lead (Figure 3, Item 4) from forward glow plug.
8. Remove glow plug lead assembly (Figure 3, Item 2).
NOTE
There are three glow plugs associated with this engine. An ohm reading check must
be performed on each glow plug to assess if a plug is faulty and needs to be
replaced.
9. Place positive multimeter lead on top tip of glow plug (Figure 3, Item 3) and negative multimeter lead on engine
block ground.
Resistance indicated on meter should be between 0.7 and 1.2 ohms.
