TM 10-8145-222-23
MAINTAINER MAINTENANCE
ENGINE MOUNTED CENTRIFUGAL CLUTCH
REPLACE
INITIAL SETUP:
Tools and Special Tools
References
SATS (WP 0096, Table 2, Item 8)
TM 10-8415-222-10
Materials/Parts
TM 10-8145-222-23P
Lock Washer, 3/8-in ID (WP 0111, Item 13)
Equipment Condition
Personnel Required
Refrigeration unit shut down (TM 10-8415-222-10)
External power cables disconnected (TM 10-8415-
Quartermaster and Chemical Equipment Repairer
222-10)
Battery disconnected (WP 0053)
REPLACE
WARNING
Falling from the roof of the MTRCS can cause serious personal injury or death. Keep
three points of contact on the MTRCS at all times.
1. Remove top-right panel (WP 0013, Remove).
2. Remove top-middle panel (WP 0013, Remove).
NOTE
The muffler is removed to provide access to the clutch. When performing muffler
removal, it will not be required to remove the muffler pipe.
3. Remove muffler (WP 0039, Remove).
NOTE
The engine to compressor V-belt must be partially removed from the engine side in
order to remove the clutch. The clutch and engine to compressor V-belt will be
removed in tandem due to the tension applied to the belt. Removing the idler pulley
will ease the tension on the belt and aid the removal of the engine to compressor V-
belt and clutch combination. The V-belt will remain partially installed over the
compressor and does not need to be fully removed.
0073-1