TM 10-8145-222-23
MAINTAINER MAINTENANCE
ENGINE TO COMPRESSOR V-BELT
REPLACE, ADJUST
INITIAL SETUP:
Tools and Special Tools
References
Face Shield (WP 0097, Item 20)
TM 10-8415-222-10
Gloves, Rubber (WP 0097, Item 21)
Refrigeration Equipment
Tool Kit (supplement) (WP 0096, Table 2, Item 7)
Service Refrigeration Ordnance
Tool Kit (WP 0096, Table 2, Item 6)
Tester, Belt Tension (TM 10-8415-222-10, Item 5)
TM 10-8145-222-23P
Materials/Parts
Equipment Condition
Lock Washer, 3/8-in ID (WP 0111, Item 13)
Refrigeration unit shut down (TM 10-8415-222-10)
External power cables disconnected (TM 10-8415-
Personnel Required
222-10)
Top-middle panel removed (WP 0013)
Utilities Equipment Repairer
Top-right panel removed (WP 0013)
REPLACE
WARNING
The MTRCS contains high voltage sources and exposed rotating parts. Make sure
that power cables are disconnected from the MTRCS and that the refrigeration unit is
shut down before performing maintenance on the unit. Failure to comply with this
warning can result in serious injury or death to personnel.
Beware of V-belts and belt driven components. The refrigeration unit may start
automatically. Before performing maintenance on any belt driven system, make sure
that the power to the unit is off.
1. Open control panel access door (Figure 1, Item 1).
2. Place POWER ON/DOWN switch (Figure 1, Item 2) on control panel to DOWN position.
3. Disconnect negative (-) battery terminal (WP 0053, Disconnect).
WARNING
Falling from the roof of the MTRCS can cause serious personal injury or death. Keep
three points of contact on the MTRCS at all times.
4. Access top of MTRCS using roof access.
0037-1