TM 10-8145-222-23
0041
TEST
1. Remove solenoid per this WP.
2. Disconnect run solenoid connector (Figure 4, Item 4) from engine harness (Figure 4, Item 5).
3. Connect jumper wire to connector pin B (white wire) and 12 volt positive (+) battery terminal (Figure 5).
Figure 5. Run Solenoid Test.
4. Connect jumper wire to connector pin C (black wire) and 12 volt negative (-) battery terminal.
If solenoid extends, reconnect solenoid per this WP.
If solenoid does not extend, replace solenoid per this WP.
5. Place MTRCS back into desired mode of operation (TM 10-8415-222-10, Operating Procedures).
END OF TASK
END OF WORK PACKAGE