|
| |
- DEPARTMENT OF THE ARMY
TECHNICAL MANUAL
- SAFETY PRECAUTIONS
- Operator's, Organizational,
Direct Support, General Support and Depot Maintenance Manual
- Section Ill. TOOLS AND TEST
EQUIPMENT REQUIREMENTS
- Operator's, Organizational,
Direct Support, General Support and Depot Maintenance Manual
- Operation in Dusty or Sandy
Conditions.
- DISTRIBUTION
- Figure 1-6. Base plan.
- Power receptacle
- Figure 2-2 Continued ((2)
Rear instruments)
- Power receptacle - continued
- Appendix B. BASIC ISSUE ITEM
LIST AND ITEMS T R O O P INSTALLED OR AUTHORIZED
- Section III. ITEMS TROOP
INSTALLED OR AUTHORIZED LIST
- Operator's, Organizational,
Direct Support, General Support and Depot Maintenance Manual
- Table 3-1. Operator/Crew
Preventive Maintenance Checks and Services
- appendix B. COMPONENTS OF END
ITEMS LIST
- Appendix D. MAINTENANCE
ALLOCATION CHART
- Section II. MAINTENANCE
ALLOCATION CHART
- Section III. SPECIAL TOOL AND
SPECIAL TEST EQUIPMENT REQUIREMENT
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- REVERSE OF DA FORM 2028-2
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- REVERSE OF DA FORM 2028-2
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- REVERSE OF DA FORM 2028-2
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- REVERSE OF DA FORM 2028-2
- Distribution
- Operator's, Organizational,
Direct Support, General Support and Depot Maintenance Manual
- Section Il. MAINTENANCE
ALLOCATION CHART
- Section Il. MAINTENANCE
ALLOCATION CHART - continued
- OPERATORS, ORGANIZATIONAL,
DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE MANUAL
- Chapter 1. INTRODUCTION
- Tabulated Data.
- Figure 1-1. Air conditioned,
front three quarter view w/shipping dimensions.
- Figure 1-2. Air conditioner,
rear view.
- Tabulated Data.
- Figure 1-1. Practical Wiring
diagram (Model 6V20)
- Figure 1-5 Refrigerant flow
diagram.
- Figure 2-1 Installation of
block-off panel.
- Inspecting and Servicing
Equipment
- Figure 2-2. Controls and
instruments.
- Figure 2-2. Controls and
instruments - continued
- Section IV. OPERATION UNDER
USUAL CONDITIONS
- Figure 2-3. Starting
instructions.
- Figure 24. Stopping
instructions.
- Figure 2-5. Operating
instructions.
- Chapter 3. OPERATOR'S AND
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
- Section III. OPERATOR'S
MAINTENANCE
- Figure 3-2. Evaporator and
condenser coil service.
- Section IV. TROUBLESHOOTING
- Section V. FIELD EXPEDIENT
REPAIRS
- Figure 3-3. Cover panel,
grills, and front access panel, removal and installation.
- Figure 3-4. Air conditioning
filter, removal and installation.
- Figure 3-5. C/B cover, fan
guard, condenser coil grill, and screen, removal and installation
- Figure 3-6. Evaporator fan
and inlet ring, removal and installation.
- Figure 3-7. Condenser fan,
removal and installation.
- Figure 3-8. Blower motor
assembly, removal and installation.
- Figure 3-9. Control panel
assembly, removal and installation.
- Connector Receptacles
- Figure 3-10. Control box
assemb[y and component removal and installation.
- Figure 3-11. Circuit breaker
linkage detail.
- Chapter 4. SHIPMENT AND
LIMITED STORAGE AND DEMOLITION TO PREVENT ENEMY USE
- Chapter 5. DIRECT SUPPORT,
GENERAL SUPPORT, AND DEPOT MAINTENANCE INSTRUCTIONS
- Table 5-1. Troubleshooting
- Section V. REMOVAL AND
INSTALLATION OF MAJOR COMPONENTS
- Figure 5-1. Electric heater
thermostat, removal and installation.
- Figure 5-2. Electric heater
elements and back pressure regulating valve, removal and
installation.
- Figure 5-3. Thermostatic
expansion valves, removal and installation.
- Figure 5-4. Thermostatic
expansion valve adjustment procedure.
- Figure 5-5.
Pressure-temperature curve.
- Figure 5-6. High pressure
cutout switch and hot gas bypass solenoid valve, removal and
installation.
- Figure 5-7. Solenoid valve,
disassembly and reassembly.
- Figure 5-8. Liquid line
solenoid valve and liquid line bypass solenoid valve, removal and
installation.
- Figure 5-9. Liquid line
solenoid valve and liquid line bypass valve, disassembly and
reassembly.
- Figure 510. Dehydrator and
pressure relief valve, removal and installation.
- Figure 5-11. Sight glass,
removal and installation.
- Evaporator Coil
- Figure 512. Evaporator coil,
removal and installation.
- Figure 513. Condenser coil,
removal and installation.
- Figure 5-14. Compressor/motor
assembly, removal and installation.
- Clean-up After a Severe
Burnout
- Figure 5-15. Casing Assembly,
Removal and Installation
- Casing Assembly
- Chapter 6. REPAIR
INSTRUCTIONS
- Figure 6-1. Pressure testing
and evacuating the refrigerant system.
- Figure 6-2. Charging the
refrigerant system.
- Figure 6-3. Pressure
temperature chart.
- Figuere 6-4. Control Panel,
disassembly and assembly
- Figure 6-5. Blower Motor
Assembly, Disassembly and Reassembly
- Blower Motor Assembly
- Appendix A. REFERENCES
- Appendix B. BASIC ISSUE ITEMS
LIST
- Section II. BASIC ISSUE ITEMS
- Appendix C. MAINTENANCE
ALLOCATION CHART
- Section II. MAINTENANCE
ALLOCATION CHART
- Section III. SPECIAL TOOL AND
SPECIAL TEST EQUIPMENT REQUIREMENT
- INDEX
- Blank Page
- DISTRIBUTION
- Blank Page
- TM-5-4120-285-15
- Blank Page
- Blank Page
- Blank page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
- Blank Page
|
|
Click
here for thousands of PDF manuals