|
| |
- OPERATOR, ORGANIZATIONAL, DS,
AND GS MAINTENANCE MANUAL
- WARNING
- Operator, Organizational,
Direct Support and General Support Maintenance Manual
- Operation in Dusty or Sandy
Conditions.
- Section II. Maitenance
Allocation Chart
- Section II. Maitenance
Allocation Chart - continued
- DISTRIBUTION
- Operator's Organizational,
Direct Support, and general Support Maintenance Manual
- Operator's Organizational,
Direct Support, and general Support Maintenance Manual - continued
- section III. Items Troop
Installed or Authorized List
- OPERATOR, ORGANIZATIONAL, DS,
AND GS MAINTENANCE MANUAL
- Table Of Contents
- LIST OF ILLUSTRATIONS
- Chapter 1. INTRODUCTION
- Figure -1. Air conditioner,
left front three-quarter view, with shipping dimensions. (Sheet 1
of 2)
- Figure 1-1 y . Air
conditioner, right front three-quarter view, with sound attenuator.
(Sheet 2 of 2)
- Figure 1-2. Air conditioner,
right rear three-quarter view.
- Tabulated Data.
- Tabulated Data - continued
- Tabulated Data - continued
- Figure 1-3. Base plan.
- Figure 1-4 x . Practical
wiring diagram.
- Chapter 2. INSTALLATION AND
OPERATING INSTRUCTIONS
- Figure 2-1. Remote control
connection installation.
- Section Il. MOVEMENT TO NEW
WORKSITE
- Figure 2-2. Controls and
instruments.
- Section IV. OPERATION UNDER
USUAL CONDITIONS
- Starting
- Figure 2-5. Operating
instructions.
- Operation in Extreme Heat.
- Operation in Dusty or Sandy
Conditions.
- Chapter 3. OPERATOR'S AND
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
- Section Ill. OPERATOR'S
MAINTENANCE
- Figure 32. Servicing
evaporator coil and condenser coil.
- Table 3-2. Troubleshooting
- Section VI. PANELS, GRILLES,
SCREENS, FAN GUARD, MIST ELIMINATOR, AIR CONDITIONING FILTER, AND
DAMPER DOOR CONTROL SPRING AND CHAIN
- Condenser Fan
- Figure 3-5. Fresh air inlet
screen, chemical and biological cover, fan guard, and condenser
grille and screen, removal and installation.
- Figure 3-6. Evaporator fan
inlet ring removal and installation.
- Figure 37. Condenser fan
removal and installation.
- Figure 37. Condenser fan
removal and installation - continued
- Section VII. ELECTRICAL
SYSTEM AND BLOWER MOTOR
- Electrical Leads
- Chapter 4. DIRECT SUPPORT AND
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
- Table 4-1. Troubleshooting
- Chapter 5. REPAIR
INSTRUCTIONS
- Figure 51. Refrigerant flow
diagram.
- Section Il. REMOVAL AND
INSTALLATION OF COMPONENTS
- Compressor Overload Protector
and Heater Thermostat
- Electrical Heater Thermostat
- Circuit Breaker
- Terminal Blocks
- Compressor Motor Contactor
and Electrical Heater Contactor
- Figure 5-6. Electrical heater
thermostat removal and installation.
- Thermostatic Expansion Valves
- Removal
- Figure 5-9. Phase sequence
relay, circuit breaker, rectifier,terminal
blocks,contractors,receptacle connctors, and control box,removal and
installation
- High Pressure Cutout Switch
- Pressure Relief Valve
- Figure 5-11. Service valves,
removal and installation.
- Condenser Coil
- Figure 513. One-tan
thermostatic expansion valve, adjustment.
- Compressor and Motor Assembly
- Servicing the Refrigerant
System
- Figure 5-17. Liquid line
solenoid valve, removal and installation.
- Figure 5-18. Liquid line
solenoid valve, disassembly and reassembly.
- Figure 5-19. Dehydrator and
pressure relief valve, removal and installation.
- Figure 5-20. Sight glass
removal and installation.
- Figure 5-21. Evaporator coil
removal and installation.
- Figure 5-22. Condenser coil,
removal and installation
- Figure 5-23. Compressor,
removal and installation.
- Figure 5-24. Compressor
heater and compressor oil level plug, removal, disassembly and
installation.
- Figure 5-25. Casing,base and
duct assembly, removal, disassembly,reassembly and installation
(Sheet 1 of 2)
- Figure 5-25. Casing,base and
duct assembly, removal, disassembly,reassembly and installation
(Sheet 2 of 2)
- Section Ill. HOSE CLAMPS,
HOSES, TUBE RETAINING STRAPS, PIPE PLUGS, RECEPTACLE HOLE COVERS AND
TUBE CLIPS
- Figure 5-26. Pressure testing
and evacuating the refrigerant system. (Sheet 1 of 3)
- Figure 5-26. Pressure testing
and evacuating the refrigerant system. (Sheet 2 of 3)
- Figure 5-26. Pressure testing
and evacuating the refrigerant system. (Sheet 3 of 3)
- Figure 5-27. Charging the
refrigerant system. (Sheet 1 of 3)
- Figure 5-27. Charging the
refrigerant system. (Sheet 2 of 3)
- Figure 5-27. Charging the
refrigerant system. (Sheet 3 of 3)
- Chapter 6. ADMINISTRATIVE
STORAGE AND INSTRUCTIONS FOR DESTRUCTION OF MATERIEL TO PREVENT
ENEMY USE
- Appendix A. REFERENCE
- Appendix B. BASIC ISSUE ITEMS
LIST
- Section Il. BASIC ISSUE ITEMS
- Appendix C. MAINTENANCE
ALLOCATION CHART
- Explanation of Columns in
Section Ill
- AIR CONDITIONER TRANE MODEL
CE20VAL4 AND MODEL CE20VAL6
- INDEX
- INDEX - continued
- INDEX - continued
- INDEX - continued
- Figure 1-4. Practical wiring
diagrams. (Sheet 1 of 2)
- THE METRIC SYSTEM AND
EQUIVALENTS
- RECOMMENDED CHANGES TO
EQUIPMENT TECHNICAL PUBLICATIONS
- TM-5-4120-222-14
- Blank Page
- DISTRIBUTION
|
|
Click
here for thousands of PDF manuals